Product Description
Seymour Duncan Studio Bass Compressor pedal
FREE shipping in the USA!
All New Look for 2026, Same Classic Performance
The Studio Bass Compressor pedal has always been a secret weapon for serious players. Now it's got the look to match. Same studio-grade performance, bold new retro housing.
The Studio Bass pedal gives you a full spectrum of compression, from subtle and transparent to tightly tamed dynamics. The 3-position mini-toggle (affecting Full, Mid, or Low frequencies) and blend knob put you in complete control by letting you mix uncompressed tones alongside the affected sound. Blend in your unadulterated clean signal, dial in enhanced mids to cut through the densest mix, or fatten up your low-end growl until it fills the room.
Find that sweet spot where harder picking lifts your dry signal right up above the compression, or blend in just a whisper of your original tone. Pick players, slap stylists, and fingerstyle technicians will all find something to love here. And when you need to step out front, there's enough clean headroom to use it as a boost for solos.
Run it at the front of your chain, leave it on all night, and let it do the heavy lifting. The Studio Bass Compressor. Built to perform and wrapped in a vintage-inspired housing that looks as good on your board as it sounds through your amp.
Specs:
Compression Ratio: Soft-knee, adjustable from 1:1 to > 20:1
Maximum Compressor Gain: +33dB
Attack Speed: Adjustable from 8ms to 27ms
Input Impedance: 1 Megohm
Output Impedance: 2.75K ohms maximum
Maximum Input Level: 3 Vrms
Distortion: < 0.3% at 300mV RMS output at 1 kHz
Noise referred to Input: -110dBV, 400 Hz - 20 kHz, input shorted
Compressor Type: Voltage Controlled Amplifier (VCA)
Power: 9V battery or 9V to 18 Vdc regulated adapter, center pin negative polarity
Current Consumption: 21mA operate, 19mA bypass
Dimensions: 2.60" wide X 5.0" long X 1.45" high
Weight: 0.67 lbs.