ObsidianWire T7 Custom Nashville 7-Way for Tele pre-wired kit
- Custom Built for 3 Pickup 'Nashville' Telecasters
- 7 Way switching' Neck + Bridge Combo
- Fits Fender® Telecaster®
- Fits Squier® Telecaster® with adjustments
What is Nashville® Wiring?
The Three Pickup Telecaster®
Nashville wiring is a super popular Tele® mod that adds a third pickup between the traditional Telecaster® neck and bridge pickups. This gives you the standard 5-way control layout that you would usually find on a Stratocaster®.
The trouble is that in gaining a middle pickup, and the cool Strat quack from the neck & middle pickup combo, you lose the traditional Telecaster neck and bridge pickup combo.
THE SOLUTION: A 7-WAY CONTROL LAYOUT
The ObsidianWire Custom Nashville 7-Way for Tele® adds a push pull switch to the tone control, which connects the neck pickup directly to the guitars volume control. This allows the possibility to play the neck and bridge pickups together again, or even all three pickups at once.
"THE 7-WAY SWITCH IS BUILT IN TO THE TONE CONTROL, SO THERE IS NO NEED TO DRILL YOUR CONTROL PLATE. THIS WILL DROP RIGHT IN"
CRYSTAL CLEAR TONE
To make your tone crystal clear at lower volumes we also include an ObsidianWire Custom Spec Treble Bleed Mod. This prevents tone 'muddiness' at low volumes by allowing high frequencies to pass along a separate path to your amp, rather than being stopped short by the increasing resistance at the volume control.
ObsidianWire T7 Custom Nashville 7-Way for Tele pre-wired kit components:
Potentiometers: Obsidian Custom CTS Pots 250K(+/-10%) Solid Shaft 1/4"
Capacitors: (150 Series Polyester Film 0.022uf) (+/-5%)
Switch: Genuine Oak 5 Way Switch
Jack: Pro-Wired Switchcraft J11 Mono
ObsidianWire T7 Custom Nashville 7-Way for Tele pre-wired kit Compatibility
American series Fender® Nashville Telecasters - Direct Fit
Mexican series Fender® Nashville Telecasters - Direct Fit
Japanese Fender & Squiers 'Nashville' - You will need to purchase a genuine Fender USA control plate and new 1/4" knobs or ObsidianWire Control plate & Knobs
ObsidianWire T7 Custom Nashville 7-Way for Tele pre-wired kit Does NOT Fit:
G & L ASAT - May be fitted with adjustments to control slot size & new genuine Fender USA control plate and new 1/4" knobs or ObsidianWire Control plate & Knobs
Other Guitars - We cannot guarantee that these will fit any other guitar.
Note: Aftermarket control plates will NOT fit. We recommend a genuine Fender control plate – Part Number: 099-2058-000 or ObsidianWire Control plate
Use US spec 1/4" Solid shaft controls such as ObsidianWire Knobs. We recommend that you check your knobs are the correct size and replace them if necessary.