The ObsidianWire Traditional Vintage Plus for Strat pre-wired kit - 250k CTS pots & 0.047uf cap
The ObsidianWire Traditional Vintage Plus harness plays homage to all of those famous Fender® Strat® sounds that we have known and loved since the 50s. Like Leo, we have an eye for detail so we have also added a few handy touches to improve the play-ability and sound.
Best of all, these are super easy to install, and allow for unlimited solder-less pickup changes with ObsidianWire Plug, Play and Enjoy connectors.
Adding the Plus to the Traditional Vintage:
The Traditional Vintage harness retains the sound of the 1954 Stratocaster®. In addition we add some ‘Plus’. This comes from the simple tweaks that we have made to the circuit, to make those Traditional Vintage sounds more usable, and accessible for the working musician.
The first tweak the most obvious and expected addition of a 5 way switch rather than the old 3 way. Artists have been using the in-between settings of the three way for near on half a century and the 5 way switch has been in use as a basic requirement since the 70s. For us it was a no brainer.
Next we connected the harsh bridge pickup to the second tone control, alongside the middle pickup so you can roll off the excess treble and add some depth to your solos.
To make your tone crystal clear at lower volumes we also include an ObsidianWire Custom Spec Treble Bleed Mod. This prevents tone 'muddiness' at low volumes by allowing high frequencies to pass along a separate path to your amp, rather than being stopped short by the increasing resistance at the volume control.
ObsidianWire Pro-Wired Electronics use the world’s best craftsmanship and components:
• 3 x ObsidianWire Custom Select Pots (Crafted by CTS) 250k (+/-6%) (Matched to +/-2%) SPLIT SHAFT
• 1 x Genuine Oak Grigsby 5-Way Switch
• 1 x Genuine Switchcraft J11 Mono Output jack
• 1 x ObsidianWire Custom Select Capacitor (NOS K42Y-2 0.047uf) (Hand Tested to +/-10%)
• 1 x ObsidianWire Premium Selected Volume Mod / Treble Bleed - Improved Volume Taper & Clarity
• 1 x Pre Printed & Easy to Follow Wiring Diagram
ObsidianWire Pro-Wired Electronics for Strat, are designed to be a direct fit for American and Mexican series Fender Stratocasters. We cannot guarantee that these will fit any other guitar.
These are also excellent upgrades for Japanese Fender & Squier Guitars with some adjustment. In the least you will need to widen the holes in the pick-guard out to around 3/8" or 10mm & get new US spec control knobs for the higher grade electronics.
At ObsidianWire we use US spec, 24 spline, split shaft controls. Using the incorrect size knobs can, and will damage your controls. We recommend that you check your knobs are the correct size and replace them if necessary. If your knobs do not press on easily, slightly crimp the top of the pots shaft together to improve the fit.