The EBS Billy Sheehan Signature Drive Deluxe pedal. FREE shipping in the USA!
More gain. The new Billy Sheehan Drive Deluxe offers significant more gain than the original version. It is also equipped with a ‘Boost’ footswitch for the Drive to really push the gain to the extreme when needed. The level of boost can be adjusted internally by a trim pot.
Phase inverter switch. This new feature changes the character of the sound a lot. By activating the inverted phase you will notice significant more low-end when using the drive compared to the original pedal.
Swappable op-amp. There are a lot of drive pedals that are considered to be classics. Many of them use some variation of a standard type of op-amp circuit design called an ‘8-pin dual inline op-amp’. The new EBS Billy Sheehan Signature Drive Deluxe offer the user the ability to change this ‘chip’ to one that offers different characteristics to the Drive effect. A list of suitable chips will be listed on the EBS website, and there might be a few different EBS branded chips coming later as well. The chip is accessed easily by removing the bottom plate of the pedal. It’s attached to the board by an IC-standard socket, and does not require any soldering to be swapped.
All the features from the original version are still there! Includes a Y-type insert cable!
The loops. You can still benefit from the super cool Drive and Clean Loop features. Use the Clean Loop to send a clean signal to an octave pedal and obtain optimized tracking while the Drive channel is still in use. Or put an Equalizer in the Drive Loop to fine tune your distortion character. There are countless options to use these loops in creative ways; these are only two examples to get your mind spinning.
The built-in compressor. The Billy Sheehan Signature pedals comes with a built-in compressor that you can leave off, in Mid or High position. The compressor helps to maintain definition of tone while you’re using heavy distortion. It also helps to blend together the distortion and clean tone better. There are two internal trim pot’s that let you change the Threshold value and adjust the level of compression in the MID position.
The controls. Both pedals include four distinct controls. Drive sets how hard the distortion ‘engine’ will work. TONE changes the character of the drive sound; LEVEL sets the level of the drive sound, and CLEAN sets the level of your clean tone.
Billy's words about the EBS Billy Sheehan Signature Drive Deluxe:
" My new Deluxe pedal has more gain! It really screams. Much more than the first version, but you can always tone it down if you like. Also, one very unique feature that I think will appeal to a lot of people is the “swappable” 8 pin dual inline op amp. You can basically make it your own signature drive by replacing the main drive chip with another of your choice! Also, there’s a phase reverse switch for the drive channel that gives tones a very different dimension. And a “boost” switch to kick the drive into a much higher gain. All exciting new features that will make it easier for players to fine tune this device to their own personal needs.
Y-type insert cable included!
The new Y-type insert cable is designed to be used with the Billy Sheehan Signature Drive loops. It features a 1/4" stereo connector at one end, that splits into two 1/4" mono connectors at the other end representing TIP and RING on the stereo connector. The cable can of course be used with other products that call for an insert cable too.
Boost Drive Footswitch. NEW!
Phase Inverter Switch. NEW!
Drive, Tone, Level and Clean controls.
Three Compressor Modes – High, Mid, Off
Clean Loop and Drive Loop (use an insert cable, such as the EBS ICY-30 to separate send and return).
Low Noise Relay Type Footswitches. NEW!
Advanced Features Inside
Replaceable Drive Circuit. NEW!*
Fine tuning trimmers to adjust Threshold level of compressor (THR.) and the level of Compression when mode switch is set to MID (COMP).
Trim pot to set the BOOST switch level inside.
Power options 9V DC battery or EBS AD-9+ Power Supply (not included)
* 8-pin Dual Inline Op-Amp Controlling Drive Circuit
|Nominal Input Level||- 8 dBv|
|Input Impedance||700 kohms|
|Gain Range*||Drive||20 - 50 dB|
|Boost||+3- 10 dB adjustable|
|Tone Filter||Range||175 - 4500 Hz|
|Nominal Loop Level||-8 dB|
|Output Impedance||Loops||2 kohms|
|Mix Level||Drive Channel||+3 dB max|
|Clean Channel||+6 dB max|
|Threshold||-25 +6 dB|
|Attack Time (80%)||< 7 ms|
|Release Time (80%)||75 ms typ|
|Makeup gain||0, +3, +6 dB|
|Output Impedance||< 100 ohms|
|Dimensions||W x H x D||3.5" x 4.5" x 1.4" (90 x 115 x 35 mm)|
|Weight||480g (1.07 lb.)|
|Type||Analog Effect, Relay type Switching|
|Power Requirements||9 - 12 V DC Regulated, 35 mA max|
|* Depending on which drive circuit being used.|